2. Drip tip with double-layered structure
3. Adjustable airflow system
4. Top refill system
1 * TFV4 Tripple Coil
1 * Silicon Ring
1 * User Manual
Smok TFV4 is one of the best tank systems in history and it is proud to offer this all-new design right now! It features two new patented sub-ohm coils: Quadruple Coil Head and Triple Coil Head, and two types of RBA head (single/dual coil), which will bring you a true premium experience. The top refill design makes filling as easy as it gets. The TFV4 also has an innovative drip tip and improved airflow system. All these are designed to provide you the unbeatable taste and quality.
Two colors to choose from
Four types of coil head to meet your different vaping demands.
The revolutionary Triple Coil Head features three coils each in a separate tube, which can get an ideal heat insulation effect and produce pure taste.
Drip tip system
The drip tip with double-layered structure
There is one-or-two millimeter spacing between the outer and inner tube, which can be a hear shield to prevent the outer tube overheating, and keep your warm vapor covered with a little coolness that will be awesome!
Adjustable airflow system
Four large airl slots evenly spaced on the drip tip, which can allow you to have an ectremely open draw!
Airflow can be adjusted freely by either turning the ring on the drip tip or the one at the base of atomizer.
Top refill system
op refill design makes filling as easy as it gets
Leak proof e-liquid slot can significantly solve leaking problem.
How to fill with e-liquid
1. Hold the tank with your left hand, and use another one to press top cap and move it counterclockwise.
2. Add e-liquid through the slot, and pay attention not to drip it into the central airflow tube.
3. Close the cap carefully and firmly. Then let it stand for several minutes to get the organic cotton completely saturated.
How to build the RBA
1. Before starting make sure your hands are clean.
2. Taking RBA apart.
3. Installing and positioning the pre-wrapped coil.
Place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined
up with the air hole, and also make sure the coil is NOT touching the base.
4. Cutting the ends of wire off.
5. Cutting a strip of cotton and make sure it's not too much and not too less.
6. Inserting the cotton, and placing it in the middle.
7. Cutting the cotton at an angle and make sure it's not too short and not too long.
8. Wet the coil with your e-liquid and sdjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.